Echo 1 7.4v 1600mAh 2s 30c LiPO for XCR PEQ Battery
[V07E02B][20433 / ECHO LIPO 7]Free Shipping for orders over $179 No Coupon neededNew to airsoft? Here are some safety tips for airsoft guns that we recommend following.
Description:
Lithium Polymer batteries are the newest available batteries for airsoft and other hobby toys. They are designed as a light weight, high output power source. This 7.4v Li-Po battery can deliver more power than 9.6v NiMH battery with only half of the size and a third of the battery cells.
Specifications:
Manufacturer: Echo 1
Voltage: 7.4v
Milliampere Hours: 1600mAh
Cell Type: Lithium Polymer (LiPo)
Connector Type: Mini
- The makers of LipoSack or its distributors or retailers assume no liability for failures to comply with these use and safety guidelines.
- By purchasing this product, the buyer assumes all risks associated with its intended use. If you cannot comply with these guidelines please return this product unused to your retailer.
1) Charge batteries in a safe area away from flammable materials and only on a non-flammable surface in a vented area. Do not discharge batteries below 3 volts/cell. Doing so may result in cell damage and subsequent cell venting upon a subsequent charge.
2) Do not recharge damaged batteries. Dispose of damaged batteries in the proper manner.
3) Some Lipo chargers on the market may have technical deficiencies that may cause it to charge the battery incorrectly or at an improper rate. It is your sole responsibility to assure that the charger you purchased works properly. Always monitor the charging process to assure batteries are being charged properly. Failure to do so may result in cell damage or fire.
4) In the event of a crash, you must remove the battery from the model for observation and place in a safe open area away from flammable materials.
LipoSack Use Instructions:
1) Ensure that charger rate is properly set and polarity is correct.
2) Attach charging leads to battery.
3) Place battery in LipoSack towards the bottom.
4) Place LipoSack on non-flammable surface.
5) Route charge leads through vent at the top seam of the LipoSack.
6) Close top flap of LipoSack and press hook and loop closure fully closed.
7) Charge battery using proper charging practices.
LiPoSack Use and Safety Instructions:
Battery safety:
∑ Lithium Polymer batteries are volatile. Failure to adhere to established charging guidelines may result in fire, personal injury and damage to property if charged or used improperly.
Airsoft GI Battery Disclaimer:
Airsoft GI is not responsible for batteries that have been damaged as a result of improper operation, storage, misuse or abuse, accident or neglect, such as physical damage resulting from misuse; contact with liquid, water, rain, extreme humidity or heavy perspiration, sand, dirt or the like, extreme heat, or food; use of the battery for commercial purposes or subjecting the battery to abnormal usage conditions, or other acts which are not the fault of Airsoft GI. Make sure you understand how your battery should be used and how long it should be charged. If you have any doubt regarding the operation, charging, or storage of your battery and/or charger, ask. A charging battery should not be left unattended and should be picked up periodically while charging to check for overheating. Do not charge batteries near flammable material. For more information regarding batteries please refer to the Frequently Asked Questions or the Airsoft GI Airsoft 101 Guide.
- Specifications
- Manufacturer: ECHO 1
|
Krytac PDW
Does this fit the krytac pdw?
2399 days ago Brian L
0
0
(I have this same question)
Staff Answer:
That may be a bit too blocky. 2399 days ago 0
0
|
1 answers 1 asked |
|
Krytac PDW
Does this fit in a krytac pdw?
2399 days ago Brian L
0
0
(I have this same question)
Staff Answer:
Possibly, though we recommend stick type batteries as the battery compartment is considerably narrow. 2397 days ago 0
0
|
1 answers 1 asked |
|
Echo 1 TRX
Will this work in the Echo 1 Troy TRX model rifle?
2533 days ago Quin H
0
0
(I have this same question)
Staff Answer:
It should 2443 days ago 0
0
|
1 answers 1 asked |
|
Fittings
I have an echo 1 precision rifle I won in the mystery box and I ordered this peq lipo so it would fit in the stock better but it has two cables but my rifle only fits one, is it okay that I only connect one or do I have to connect both to prevent shorting out?
2556 days ago Tristan S
0
0
(I have this same question)
Staff Answer:
The tamiya connector goes for the rifle, the white plug goes to the battery charger when charging. 2442 days ago 0
0
|
1 answers 1 asked |
|
FIt | 0 answers 2 asked |
|
PEQ box | 0 answers 4 asked |