Modify Low Resistance AEG Switch & Wire Assembly for M4/M16 (Front/Ultra Plug)
[14333 / MOD WH M4 ULTRA]
$30.63 $25.12
Displaying 1 to 1 (of 1 reviews) Result Pages:  1 
by D. GREGG verified buyer Date Added: Tuesday 01 April, 2014
verified buyer
For: Modify Low Resistance AEG Switch & Wire Assembly for M4/M16 (Front/Ultra Plug)
Product Information:
Upgrading the Stock Wires that came with my 06' ICS M4A1 (Replace those ASAP, very cheap). and decided to go with these. Had to fiddle with the plastic trigger piece very minutely but really did slide right in. Noticed that when I was installing the trigger and the trigger switch slide that the gap between the contacts was almost too close. Bent them out a little bit only after i discovered that the trigger slide actually got stuck!!! Also, keep in mind that using this wire assembly removes the "Electrical" Safety of the safety switch. So, if the Trigger Slide where to get stuck in the field, it would continue to fire until you pulled the battery. Lastly, I would HIGHLY Recommend getting a MOSFET with this puppy... if you are going low resistance, spare no expense.

Low Resistance Silver Coated
Heat Shrink Wire covered in "Critical Pinch/stress Areas"
Came with Deans Connectors (Cheaper Deans, but still deans)
Easy Install but make sure you are comfortable opening a gearbox!!!

"Red" line leading to motor was actually too long (Note: did not run them through the wrong holes, trust me!)
Motor connectors need a little extra layering, use some electrical tape.
Had to bend the motor connectors, just be careful and do with your fingers slowly!
Displaying 1 to 1 (of 1 reviews) Result Pages:  1 
Back Write Review

Out of Stock

Airsoft GI 21077 Commerce Pointe Dr Walnut, CA 91789 Phone: (909) 598-1936
GI Tactical 9047 W Broad St. Suite # 5 Richmond, VA 23294 Phone: (804) 447-3334
GI Tactical TX 4720 Highway 121 Suite # 160 Plano, TX 75024 Phone: (469) 362-8771

AIRSOFT GI SUPPORTS Paralyzed Veterans AIRSOFT GI SUPPORTS Wounded Warrior Project

AIRSOFT GI SUPPORTS American Red Cross Airsoft GI Walk-In Store is a drop off location for Toys for Tots

Airsoft GI is part of the NRA Business Alliance

AIRSOFT GI Field Partners

Airsoft GI field partner D14 Airsoft

Copyright © 2017 Airsoft GI
Disclaimer: All airsoft guns are required to have the tip (1/4 inch) of the barrel permanently colored in blaze orange. No person may openly display or expose any imitation firearm (replica firearm), in a public place. The term "public place" means an area open to the public or exposed to public view and includes streets, sidewalks, bridges, alleys, plazas, parks, driveways, parking lots, automobiles, whether moving or not, and buildings open to the general public, including those that serve food or drink, or provide entertainment, and the doorways and entrances to buildings or dwellings and the grounds enclosing them.
Any person who changes, alters, removes, or obliterates any coloration or markings that are required for by any applicable state or federal law or regulation, for any imitation firearm (replica firearm), or device in any way that makes the imitation firearm (replica firearm) or device look more like a firearm is guilty of violating the state or federal law.
By accessing the Site, you certify that you are older than 18 years of age or the age of majority where you live, whichever is older; that you are the owner of any credit card used to purchase on items on the Site; that you are familiar with all local laws in your area affecting your legal right to access airsoft products; that any products you buy are for your own private enjoyment and that you will NEVER share these products with a minor in ANY WAY.

DB1 Current Parse Time: 0.100 s with 25 queries