Airsoft GI small logo

Accessories / BBs / Magazines / Batteries / Gas » Batteries / Chargers / Gas » Lithium Battery Bookmark and Share

Tenergy LiPo 11.1V 1000mAh 20C Stick Battery & Charger Package

[12107 / Black Friday Special]
$47.48
Write Review ❤ Add to Wishlist
OUT OF STOCK

Please Note: Lithium Polymer batteries MUST be charged with a Lithium Polymer Balance Charger!

Black Friday Special

The Airsoft GI Black Friday Specials are one of the few ways to save money this holiday season. Lithium polymer batteries provide a higher output over traditional NiMH / NiCd batteries. Not only will this package allow you to save more than $10, but the included charger is specifically designed to properly charge your battery quickly and safely allowing you to get out and play.

Tenergy 11.1v 1000mAh Battery

Description:
Lithium Polymer batteries are the newest available batteries for airsoft and other hobby toys. They are designed as a light weight, high output power source. This 11.1v Li-Po battery can deliver more power than 12v Ni-MH large type battery with only half of the size and a third of the battery cells.

Specifications:
Manufacturer: Tenergy
Voltage: 11.1v
Milliampere Hours: 1000mAh
Cell Type: Lithium Polymer (LiPo)
Connector Type: Mini
Recommended Fit: M4A1, AK, M14, MP5, G36

    LiPoSack Use and Safety Instructions:
    Battery safety:

    ∑ Lithium Polymer batteries are volatile. Failure to adhere to established charging guidelines may result in fire, personal injury and damage to property if charged or used improperly.

  • The makers of LipoSack or its distributors or retailers assume no liability for failures to comply with these use and safety guidelines.
  • By purchasing this product, the buyer assumes all risks associated with its intended use. If you cannot comply with these guidelines please return this product unused to your retailer.


    1) Charge batteries in a safe area away from flammable materials and only on a non-flammable surface in a vented area. Do not discharge batteries below 3 volts/cell. Doing so may result in cell damage and subsequent cell venting upon a subsequent charge.
    2) Do not recharge damaged batteries. Dispose of damaged batteries in the proper manner.
    3) Some Lipo chargers on the market may have technical deficiencies that may cause it to charge the battery incorrectly or at an improper rate. It is your sole responsibility to assure that the charger you purchased works properly. Always monitor the charging process to assure batteries are being charged properly. Failure to do so may result in cell damage or fire.
    4) In the event of a crash, you must remove the battery from the model for observation and place in a safe open area away from flammable materials.

    LipoSack Use Instructions:

    1) Ensure that charger rate is properly set and polarity is correct.
    2) Attach charging leads to battery.
    3) Place battery in LipoSack towards the bottom.
    4) Place LipoSack on non-flammable surface.
    5) Route charge leads through vent at the top seam of the LipoSack.
    6) Close top flap of LipoSack and press hook and loop closure fully closed.
    7) Charge battery using proper charging practices.

Airsoft GI Battery Disclaimer:
Airsoft GI is not responsible for batteries that have been damaged as a result of improper operation, storage, misuse or abuse, accident or neglect, such as physical damage resulting from misuse; contact with liquid, water, rain, extreme humidity or heavy perspiration, sand, dirt or the like, extreme heat, or food; use of the battery for commercial purposes or subjecting the battery to abnormal usage conditions, or other acts which are not the fault of Airsoft GI. Make sure you understand how your battery should be used and how long it should be charged. If you have any doubt regarding the operation, charging, or storage of your battery and/or charger, ask. A charging battery should not be left unattended and should be picked up periodically while charging to check for overheating. Do not charge batteries near flammable material. For more information regarding batteries please refer to the Frequently Asked Questions or the Airsoft GI Airsoft 101 Guide.

Tenergy Li-Po / LiFePO4 Battery Charger

The Tenergy Li-Po / LiFePO4 Battery Charger is a very basic charger that is able to balance and charge your Li-po or LiFePO4 batteries. This charger extends the life of your battery by charging each cell individually to ensure that the cell is properly charged before use. The Tenergy Li-Po / LiFePO4 Battery Charger features a light weight and durable polymer case and is able to charge a battery with 1-4 cells.

Specifications:
Manufacturer: Tenergy
Model: Li-Po / LiFePO4 Battery Charger
Color: Silver
Package Includes: One (1) Charger

Specifications
Manufacturer: Tenergy
Color: Black / Silver
Material: Plastic / Metal
Package Includes: One (1) Battery & Charger
No reviews | Write a Review
 
charger
will the charger that come with this work with a 9.6v battery?

1907 days ago
jason d
0
0

(I have this same question)
Staff Answer:
The charger in the package is strickly meant to charge LiPo Batteries.

1907 days ago
0
0
1 answers
1 asked
 
back in stock
I would like to know if the battery and charger pack is back in stock? I ordered it in stock like 3 weeks ago.

1679 days ago
Nicholas P
0
0

(I have this same question)
Staff Answer:
Please contact Customer Service for questions about your order

1678 days ago
0
0
1 answers
1 asked
 
Will it fit 0 answers
1 asked
 
Battleaxe stoc
will this battery fit in a Madbull Battleaxe stock?

1721 days ago
Johnnie L
0
0

(I have this same question)
Staff Answer:
It should fit in the buffer tube

1720 days ago
0
0
1 answers
1 asked
 
VFC VR 16 Fighter Carbine 0 answers
1 asked
 
dimensions 0 answers
1 asked
 
Will it fit
Will it fit and work well with the krytac m4 crb please answer fast thank you

1793 days ago
Cheryl S
0
0

(I have this same question)
Staff Answer:
It should fit. If you need to know something right away, contact our customer service department

1791 days ago
0
0
1 answers
1 asked
 
VFC 416
Will this battery fit in the buffer tube of a VFC HK 416?

1816 days ago
Jared N
0
0

(I have this same question)
Staff Answer:
It should

1816 days ago
0
0
1 answers
1 asked
 
VFC SCAR L / SCAR H
Will this fit in the VFC SCAR L or SCAR H

1819 days ago
Andrew H
0
0

(I have this same question)
Staff Answer:
It should fit, but will void the warranty

1818 days ago
0
0
1 answers
1 asked
 
Right fit
Would this fit in a buffer tube?

1825 days ago
Trey D
0
0

(I have this same question)
Staff Answer:
This should fit in most AEG buffer tubes.

1823 days ago
0
0
1 answers
1 asked
 
Fit
Can this fit in a lancer tactical PEQ box

1829 days ago
Eli H
0
0

(I have this same question)
Staff Answer:
no

1827 days ago
0
0
1 answers
1 asked
 
KWA SR10 compatable
Are the tamiya plugs the right size for the KWA SR10?

1835 days ago
Trey D
0
0

(I have this same question)
Staff Answer:
Yes.

1834 days ago
0
0
1 answers
1 asked
 
Is this a smart charger?
Will this battery stop charging when the battery is completely charged?

1844 days ago
Antonio A
0
0

(I have this same question)
Staff Answer:
Yes it is a smart charger

1841 days ago
0
0
1 answers
1 asked
 
will it fit in an ARX-160 Elite
if so does it come with a charger or no???

1907 days ago
Victoria S
0
0

(I have this same question)
Staff Answer:
This should fit, however an 11.1 is not recommended.

1907 days ago
0
0
1 answers
1 asked
 
Will this fit in a magpul pts ctr stock w/ buttpad v.2
Wondering what lipo battery will fit in my magpul stock

1913 days ago
Hunter D
0
0

(I have this same question)
Staff Answer:
This may fit, however it all depends on the amount of room inside of your buffer tube.

1911 days ago
0
0
1 answers
1 asked
 
Will the fit a Small-Type Connector on an Apex m4?
The product information says mini connector.

1915 days ago
Ryan M
0
0

(I have this same question)
Staff Answer:
A small and mini connector are the same

1914 days ago
0
0
1 answers
1 asked
 
Does This Come With a Lipo sack?
Does This Come With a Lipo sack?

1945 days ago
Sten C
0
0

(I have this same question)
Staff Answer:
Thick package deal does not include the LiPo sack.

1945 days ago
0
0
1 answers
1 asked
 
will this work with an er-25
just wondering if it will work well with the gun but also if it will fit in the stock crane-stock

1951 days ago
jeremy s
0
0

(I have this same question)
Staff Answer:
It should work.

1951 days ago
0
0
1 answers
1 asked
 
Will this battery work well with my CM032 M14 AEG?
or should I use like a 9.6v LiPo?

1955 days ago
Jack u
0
0

(I have this same question)
Staff Answer:
This should work. Keep in mind that using an 11.1v Lipo will put rapid wear & tear on your gun.

1952 days ago
0
0
1 answers
1 asked
 
will this fit in an AR57?
I want to know if this will fit inside of the crane stock inclded with the AR57

1978 days ago
Joe S
0
0

(I have this same question)
Staff Answer:
This should fit.

1977 days ago
0
0
1 answers
1 asked
 
Will this fit in a crane stock???
I have an Echo 1 XCR-L Polymer version that has a 9.6v nunchuck battery that fits in the crane stock and i was wondering if this battery should fit as well.

1986 days ago
Michael B
0
0

(I have this same question)
Staff Answer:
This should fit in a crane stock okay.

1985 days ago
0
0
1 answers
1 asked

Search Tags: Season Deal Combo Combination Bundle Savings 1000 mah 20 C Lipoly Lithium Polymer 11.1 V Volts Volt
This product was added to our catalog on Monday 14 January, 2013.
Copyright © 2019 Airsoft GI
Disclaimer:

All airsoft guns are required to have the tip (1/4 inch) of the barrel permanently colored in blaze orange. No person may openly display or expose any imitation firearm (replica firearm), in a public place. The term "public place" means an area open to the public or exposed to public view and includes streets, sidewalks, bridges, alleys, plazas, parks, driveways, parking lots, automobiles, whether moving or not, and buildings open to the general public, including those that serve food or drink, or provide entertainment, and the doorways and entrances to buildings or dwellings and the grounds enclosing them.

Any person who changes, alters, removes, or obliterates any coloration or markings that are required for by any applicable state or federal law or regulation, for any imitation firearm (replica firearm), or device in any way that makes the imitation firearm (replica firearm) or device look more like a firearm is guilty of violating the state or federal law.

By accessing the Site, you certify that you are older than 18 years of age or the age of majority where you live, whichever is older; that you are the owner of any credit card used to purchase on items on the Site; that you are familiar with all local laws in your area affecting your legal right to access airsoft products; that any products you buy are for your own private enjoyment and that you will NEVER share these products with a minor in ANY WAY.