0 items
New Products
Pre-Order Products
GI Shockers


CQB Spotlight Field Spotlight Sniper Spotlight
Modify VSR 10 Hop Up Bucking
[09758 / MOD HB VSR / GB-05-62]
Displaying 1 to 1 (of 1 reviews) Result Pages:  1 
by A. EGERTON Date Added: Monday 10 February, 2014
For: Modify VSR 10 Hop Up Bucking
Product Information:
Purchased this for a KJW M700 build. I usually advise Nineball buckings, but as they are getting harder to find and more expensive, I figured I would give this one a try, as there was little information out there on it. I wanted to share my experience so that others can hopefully make a better informed decision.

Upon first inspected, I noted that the nub inside is a typical flat type. I was glad to see this, as the Firefly style 2-prong nubs were typically too prone to tearing for my liking. However: the rubber Modify chose to use is very soft. So soft, that I was hesitant to even install it in the M700, which was going to be shooting 550 FPS once the HPA rig was adjusted. But I decided to at least give it a try. I slipped it over the inner barrel, put the 2 halves of the hop-up over it, tightened down the screw, and found that the bucking was so severely undersized that I could slip the clam shell hop-up right off the bucking without loosening the screw that held the 2 halves together. The hop-up would slide back and forth over the bucking with ease upon re-installation. I would estimate a .030"-.040" undersizing of the outer diameter.

A soft bucking is not a bad thing for lower FPS builds, but the poor sizing would create massive blowby inside the hop-up assembly. I highly advise against this bucking.

Standard flat nub (debatable, but favorable to me)
Cheaper than Nineball

Severely undersized
Very soft (softer than Nineball, King Arms, factory KJW, factory JG BAR-10...)
Displaying 1 to 1 (of 1 reviews) Result Pages:  1 
Back Write Review

Add to Cart

Copyright © 2014 Airsoft GI

DB1 Current Parse Time: 0.362 s with 33 queries