0 items
New Products
Pre-Order Products
GI Shockers


CQB Spotlight Field Spotlight Sniper Spotlight
Bravo Advanced AEG MOSFET Wire Assembly Unit #3 (Fully Computerized)
[06869 / BRAVO AMU 3]
Displaying 1 to 2 (of 2 reviews) Result Pages:  1 
by C. GARCIA verified buyer Date Added: Saturday 21 August, 2010
verified buyer
For: Bravo Advanced AEG MOSFET Wire Assembly Unit #3 (Fully Computerized)
Product Information:
Got this to reduce tigger lag and to have 3 round burst. Since I mostly play field game 3 rnd burst works better than single shot. The unit came with good instructions for wiring it in. I installed this on my KWA KM4 RIS. you do have to open up the gear box to install this and getting the KM4 apart for the 1st time is a royal pain. Once installed the unit work perfectly and was easy to program, I am very happy with this mosfet.

easy to program
good instructions
has lipo alarm
start up codes make trouble shooting easy ( I had a pinched trigger wire after installing)

For a KWA M4 the wires that came with the unit for the motor can not be used as they are to thick for the pistol grip, this causes the motor to not fit.

wire plug in ports are a little small making it hard to get the motor and battery wires in so they could be screwed down.
by J. TER HAAR Date Added: Wednesday 21 July, 2010
For: Bravo Advanced AEG MOSFET Wire Assembly Unit #3 (Fully Computerized)
Product Information:

Fully computer controlled MOSFET switching with Active Braking
Full over current, voltage, and temperature monitoring and protection
Normal, 3-round burst, and Semi Only Operation.
Automation 3-round burst to full auto operation after trigger is held .04 secondS
Full PWM motor speed control (Ability to Decrease ROF and Increase to 100%
Soft Start to reduce motor and drive train wear
Very low trigger switch current (~10mA)
Self diagnostics at power-up and during operation.
Mode, Burst time and Motor Speed are programmed via trigger pulls
Low sound level motor "vibration" is used to signal the user
Fits in present fuse holder space and replaces old fuse with high speed electronic monitoring
Gearbox wires included
T connectors, Angled motor plugs and shrink wrap included

Technical Details
Size: 50.8mm x 16.5mm x 13.5mm. 14grams (will fit in a 19mm diameter tube)
Voltage Range: Accepts from 7.0v to 18.0v
Power: Rated for 500amps peak, 60amps continuous. It can deliver 7000 watts of power.
Low Battery Warning: Low Battery signal happens when battery drops to 85% of the initial voltage. Shutdown will occur when the battery voltage is either under 7.0V or drops below 80% capacity. Strongly recommended for use with Li-Poly batteries.


Displaying 1 to 2 (of 2 reviews) Result Pages:  1 
Back Write Review

Out of Stock

Copyright © 2014 Airsoft GI

DB5 Current Parse Time: 0.784 s with 28 queries