|| verified buyer
For: Modify Low Resistance AEG Switch & Wire Assembly for M4/M16 (Front/Ultra Plug)Product Information:
Upgrading the Stock Wires that came with my 06' ICS M4A1 (Replace those ASAP, very cheap). and decided to go with these. Had to fiddle with the plastic trigger piece very minutely but really did slide right in. Noticed that when I was installing the trigger and the trigger switch slide that the gap between the contacts was almost too close. Bent them out a little bit only after i discovered that the trigger slide actually got stuck!!! Also, keep in mind that using this wire assembly removes the "Electrical" Safety of the safety switch. So, if the Trigger Slide where to get stuck in the field, it would continue to fire until you pulled the battery. Lastly, I would HIGHLY Recommend getting a MOSFET with this puppy... if you are going low resistance, spare no expense.
Low Resistance Silver Coated
Heat Shrink Wire covered in "Critical Pinch/stress Areas"
Came with Deans Connectors (Cheaper Deans, but still deans)
Easy Install but make sure you are comfortable opening a gearbox!!!
"Red" line leading to motor was actually too long (Note: did not run them through the wrong holes, trust me!)
Motor connectors need a little extra layering, use some electrical tape.
Had to bend the motor connectors, just be careful and do with your fingers slowly!