I have owned this gun for over 1.5 years. Shows normal wear and tear but functions beautifully. I did not receive a hop-up tool with my gun for whatever reason, but ended up buying one because the hop-up is had to adjust with midsized and larger fingers.
The recoil spring that is stock in this gun sucks, plain and simple. If the gun is held at higher than a 45 degree angle upward the slide probably wont come all the way foreword after a shot. Also due to the weak spring your rate of fire is reduced because the slide does not return fast enough. Luckily there is an upgrade spring available for the recoil rod and I would highly recommend it.
After the upgraded recoil spring is installed this gun really glows.
Its overall construction is as follows:
Metal slide, inner and outer barrel, slide lock, trigger, hammer, recoil spring/rod and front/rear sights.
High quality ABS Lower and de-cocker
The Magazine is full metal aside from the rubber seals.
I have 3 mags for my gun and have replaced fill valves on two of them, common issue if you do not maintain the seals regularly.
This gun does shoot hard. I run propane through it w/o any problems and am very satisfied with my range, 60ft with high accuracy.
Comfortable to hold (smaller hands have a hard time gripping the gun)
Mags are durable(if maintained properly)
Hop-up is accurate
close to real steel weight w/mag in mag well
Its an H&K replica!
Stock recoil spring is too weak.
I didn't get a hop-up tool (I did not purchase the gun from this site)
Cannot find a threaded barrel for this gun ANYWHERE!!!!!!!!!!!
No trade marks