Airsoft GI small logo

Tenergy LiPo 11.1v 1000mAh 3s 20C Tri-panel Pack Battery

[K15G00][11916 / 31600 / LIPO11.1V1000N]
$23.21
( 1 Reviews ) ❤ Add to Wishlist
OUT OF STOCK
Orders over $179 qualify for free shipping
Free Shipping for orders over $179 No Coupon needed
New to airsoft? Here are some safety tips for airsoft guns that we recommend following.

Please Note: Lithium Polymer batteries MUST be charged with a Lithium Polymer Balance Charger!

Lithium Polymer batteries are the newest available batteries for airsoft and other hobby toys. They are designed as a light weight, high output power source. This 11.1v Li-Po battery can deliver more power than 12v Ni-MH large type battery with only half of the size and a third of the battery cells.

While Tenergy batteries are great, I Power LiPO batteries are now available with more mAh for an affordable price! Check out I Power LiPO batteries by click HERE.

Specifications:
Manufacturer: Tenergy
Voltage: 11.1v
Milliampere Hours: 1000mAh
Cell Type: Lithium Polymer (LiPo)
Connector Type: Mini
Recommended Fit: M4A1, AK, M14, MP5, G36

    LiPoSack Use and Safety Instructions:
    Battery safety:

    ∑ Lithium Polymer batteries are volatile. Failure to adhere to established charging guidelines may result in fire, personal injury and damage to property if charged or used improperly.

  • The makers of LipoSack or its distributors or retailers assume no liability for failures to comply with these use and safety guidelines.
  • By purchasing this product, the buyer assumes all risks associated with its intended use. If you cannot comply with these guidelines please return this product unused to your retailer.


    1) Charge batteries in a safe area away from flammable materials and only on a non-flammable surface in a vented area. Do not discharge batteries below 3 volts/cell. Doing so may result in cell damage and subsequent cell venting upon a subsequent charge.
    2) Do not recharge damaged batteries. Dispose of damaged batteries in the proper manner.
    3) Some Lipo chargers on the market may have technical deficiencies that may cause it to charge the battery incorrectly or at an improper rate. It is your sole responsibility to assure that the charger you purchased works properly. Always monitor the charging process to assure batteries are being charged properly. Failure to do so may result in cell damage or fire.
    4) In the event of a crash, you must remove the battery from the model for observation and place in a safe open area away from flammable materials.

    LipoSack Use Instructions:

    1) Ensure that charger rate is properly set and polarity is correct.
    2) Attach charging leads to battery.
    3) Place battery in LipoSack towards the bottom.
    4) Place LipoSack on non-flammable surface.
    5) Route charge leads through vent at the top seam of the LipoSack.
    6) Close top flap of LipoSack and press hook and loop closure fully closed.
    7) Charge battery using proper charging practices.

Airsoft GI Battery Disclaimer:
Airsoft GI is not responsible for batteries that have been damaged as a result of improper operation, storage, misuse or abuse, accident or neglect, such as physical damage resulting from misuse; contact with liquid, water, rain, extreme humidity or heavy perspiration, sand, dirt or the like, extreme heat, or food; use of the battery for commercial purposes or subjecting the battery to abnormal usage conditions, or other acts which are not the fault of Airsoft GI. Make sure you understand how your battery should be used and how long it should be charged. If you have any doubt regarding the operation, charging, or storage of your battery and/or charger, ask. A charging battery should not be left unattended and should be picked up periodically while charging to check for overheating. Do not charge batteries near flammable material. For more information regarding batteries please refer to the Frequently Asked Questions or the Airsoft GI Airsoft 101 Guide.

Specifications
Manufacturer: Tenergy


see 1 reviews | Write a Review
P. HRUBY | 2014-06-07
Product Information:
If you have a crane stock this battery should fit. I used this battery in my kwa crane stock as well as a g&g crane stock. I have a g&p shorty stock on my m4 now so I dont need to buy tri panel batteries now but I like this battery as well as not wanting to wait for shipping im going to airsoft gi this week to get another one. If you have pre-engagement problems this battery may also be good for you because its a constant 20c discharge and doesnt jump up. I soldered this battery to deans so I cant tell you if the mini tamiya connectors were good or not since i never used them. My stubby shoots 35 rps with this battery and it stays relatively cool, even when using semi very fast.

Pros:
-fits in crane even with a mosfet
-fits in dull stocks (of course) and might fit in buffer tube
-constant 20c discharge
-quality seems pretty good
-this battery is pretty good at staying cool
-this review goes for the other tenergy 11.1 that is just like this but not a tri panel (I own one of those also)

Cons:
-comes stock on small tamiya connecors (not a con for everyone)
-even though quality is good sometimes i feel a wire may come unconnected from a cell
 
Will this be compatible with a KWA SR10?
First time buyer

2285 days ago
Dave K
0
0

(I have this same question)
Staff Answer:
Yes it is.

2174 days ago
0
0
1 answers
1 asked
 
Will this fit in the lvoa-c? And is it the ideal battery?
Inquiring on buying the lvoa and want to make sure to get the correct battery

2409 days ago
John S
0
0

(I have this same question)
Staff Answer:
Yes, it would fit.

2162 days ago
0
0
1 answers
1 asked
 
Will it fit?
Will it fit in a PTS enhanced polymer Stock?

2542 days ago
Nathan B
0
0

(I have this same question)
Staff Answer:
Yes it will.

2162 days ago
0
0
1 answers
1 asked
 
Will it fit?
Will this battery fit in the ASG CZ Scorpion?

3271 days ago
cameron b
2
0

(I have this same question)
Staff Answer:
It hsould

3269 days ago
0
0
1 answers
2 asked
 
fit
will this fit in a kwa cqr mod 2 with no mods or adapters?

3355 days ago
joe m
0
0

(I have this same question)
Staff Answer:
It should

3339 days ago
0
0
1 answers
1 asked
 
Is one of the sells supposed to be fatter and bulging compared to the others?
I just bought and received one of these lipos and i have never used it or even plugged it in. I was about to plug it in and i noticed the cell with the sticker on it is fatter than the others and feels like it has a liquid inside. I want to know before i plug it in because this is my first lipo and i dont want to start a fire. thank you.

3371 days ago
Tammy G
0
0

(I have this same question)
Staff Answer:
Please contact our customer service department for support

3370 days ago
0
0
1 answers
1 asked
 
Krytac stock
Will this fit a krytac trident SPR M4

3389 days ago
Jakob R
0
0

(I have this same question)
Staff Answer:
Yes

3386 days ago
0
0
1 answers
1 asked
 
How long do I charge this for?
This is the second one I have owned of this exact battery. I have no idea how long to charge it.

3578 days ago
David H
0
0

(I have this same question)
Staff Answer:
You have to use a LiPo charger which will shut off when done charging

3577 days ago
0
0
1 answers
1 asked
 
Where is part that connects to gun and charger?
the Tamiya and other thing

3663 days ago
Domenick D
0
0

(I have this same question)
Staff Answer:
The longer piece (tamiya connector) connects the battery to the airsoft gun. The shorter piece connects the battery to any LiPO charger.

2162 days ago
0
0
the Tamiya and other thing

3663 days ago
Domenick D
0
0

(I have this same question)
it could be in the stock or somewhere else (refer to the guns manual)

2454 days ago
joshua l
0
0
2 answers
1 asked
 
What connecter is it
Is it a Small Tamiya Connector?

3666 days ago
Joshua B
0
0

(I have this same question)
Staff Answer:
The battery should have a Small Tamiya Connector.

3666 days ago
0
0
1 answers
1 asked
 
Will this Battery fit in a crane stock?
Will this battery fit in a crane stock? FMG4?

3671 days ago
Preston H
0
0

(I have this same question)
Staff Answer:
This should fit in a crane stock.

3668 days ago
0
0
1 answers
1 asked
 
Will this fit in the KM4 RIS stock?
I currently own the 11.1V stick variant which fits in my VFC 416 buffer tube however not in my KM4 RIS.

3683 days ago
Sandor H
0
0

(I have this same question)
Staff Answer:
This should fit okay. Keep in mind that an 11.1v Lipo may void your warranty with KWA.

3682 days ago
0
0
1 answers
1 asked
 
will it fit
Will this fit into the FMG4 series?

3685 days ago
Jacob F
0
0

(I have this same question)
Staff Answer:
This should fit.

3682 days ago
0
0
1 answers
1 asked
 
Fitting?
Will this batter fit inside the hand guards of a G&G MP5 by H&K

3704 days ago
Chris M
0
0

(I have this same question)
Staff Answer:
This battery should fit.

3703 days ago
1
0
1 answers
1 asked

Other Great Deals and Accessories:
Select the item from the Drop Down Menu and click add.

Charger
 
Gear Accessories
 
LIPO Battery Safety information image

Search Tags: Lithium Polymer 2 Cell M4 KWA MK36 G36 AEG AK S MK5K 11.1 1000 LiPo Lithium Polymer Phosphate PO4 Li ion Fe Iron

For Questions, Answers and Comments:

Talk about the Tenergy LiPo 11.1v 1000mAh 3s 20C Tri-panel Pack Battery with your friends on the facebook comments box below:
Copyright © 2024 Airsoft GI
Disclaimer:

All airsoft guns are required to have the tip (1/4 inch) of the barrel permanently colored in blaze orange. No person may openly display or expose any imitation firearm (replica firearm), in a public place. The term "public place" means an area open to the public or exposed to public view and includes streets, sidewalks, bridges, alleys, plazas, parks, driveways, parking lots, automobiles, whether moving or not, and buildings open to the general public, including those that serve food or drink, or provide entertainment, and the doorways and entrances to buildings or dwellings and the grounds enclosing them.

Any person who changes, alters, removes, or obliterates any coloration or markings that are required for by any applicable state or federal law or regulation, for any imitation firearm (replica firearm), or device in any way that makes the imitation firearm (replica firearm) or device look more like a firearm is guilty of violating the state or federal law.

By accessing the Site, you certify that you are older than 18 years of age or the age of majority where you live, whichever is older; that you are the owner of any credit card used to purchase on items on the Site; that you are familiar with all local laws in your area affecting your legal right to access airsoft products; that any products you buy are for your own private enjoyment and that you will NEVER share these products with a minor in ANY WAY.