Valken Energy 11.1v 1200mAh 30C LiPO Stick Battery
[K07C00 / SF11][14733 / 48191]Free Shipping for orders over $179 No Coupon neededNew to airsoft? Here are some safety tips for airsoft guns that we recommend following.
Please Note: Lithium Polymer batteries MUST be charged with a Lithium Polymer Balance Charger!
Description:
Lithium Polymer batteries are the newest available batteries for airsoft and other hobby toys. They are designed as a light weight, high output power source. This 11.1v Li-Po battery can deliver far more power than 9.6v Ni-MH large type battery with only half of the size and a third of the battery cells.
Specifications:
Manufacturer: Valken
Voltage: 11.1v
Milliampere Hours: 1200mAh
Cell Type: Lithium Polymer (LiPo)
Connector Type: Mini
Recommended Fit: M4A1, AK, M14, MP5, G36
- The makers of LipoSack or its distributors or retailers assume no liability for failures to comply with these use and safety guidelines.
- By purchasing this product, the buyer assumes all risks associated with its intended use. If you cannot comply with these guidelines please return this product unused to your retailer.
1) Charge batteries in a safe area away from flammable materials and only on a non-flammable surface in a vented area. Do not discharge batteries below 3 volts/cell. Doing so may result in cell damage and subsequent cell venting upon a subsequent charge.
2) Do not recharge damaged batteries. Dispose of damaged batteries in the proper manner.
3) Some Lipo chargers on the market may have technical deficiencies that may cause it to charge the battery incorrectly or at an improper rate. It is your sole responsibility to assure that the charger you purchased works properly. Always monitor the charging process to assure batteries are being charged properly. Failure to do so may result in cell damage or fire.
4) In the event of a crash, you must remove the battery from the model for observation and place in a safe open area away from flammable materials.
LipoSack Use Instructions:
1) Ensure that charger rate is properly set and polarity is correct.
2) Attach charging leads to battery.
3) Place battery in LipoSack towards the bottom.
4) Place LipoSack on non-flammable surface.
5) Route charge leads through vent at the top seam of the LipoSack.
6) Close top flap of LipoSack and press hook and loop closure fully closed.
7) Charge battery using proper charging practices.
LiPoSack Use and Safety Instructions:
Battery safety:
∑ Lithium Polymer batteries are volatile. Failure to adhere to established charging guidelines may result in fire, personal injury and damage to property if charged or used improperly.
Airsoft GI Battery Disclaimer:
Airsoft GI is not responsible for batteries that have been damaged as a result of improper operation, storage, misuse or abuse, accident or neglect, such as physical damage resulting from misuse; contact with liquid, water, rain, extreme humidity or heavy perspiration, sand, dirt or the like, extreme heat, or food; use of the battery for commercial purposes or subjecting the battery to abnormal usage conditions, or other acts which are not the fault of Airsoft GI. Make sure you understand how your battery should be used and how long it should be charged. If you have any doubt regarding the operation, charging, or storage of your battery and/or charger, ask. A charging battery should not be left unattended and should be picked up periodically while charging to check for overheating. Do not charge batteries near flammable material. For more information regarding batteries please refer to the Frequently Asked Questions or the Airsoft GI Airsoft 101 Guide.
- Specifications
- Manufacturer: Valken
My AEG, smart charger, LiPo battery, laser, red dot sight, and vertical grip was delivered on time and in perfect condition. Started charging the LiPo battery after buying ammo the following day. It charged for approximately 1 hour and then I plugged it into my SCAR for target practice. Afterwards, I charged it for a second time starting at 6pm. At 7:30pm, the entire battery exploded into molten, acidic lava. After I put the electrical fire out I called 911. There is absolutely nothing left of the battery except melted carpet and charred marks on the floor of my bedroom.
Pros:
On the first charge, INSANE ROF!!!
Cons:
This could have burned my house down!! Luckily I heard the explosion, and then saw the flames. Buyer beware when charging your LiPo Stick Battery. The smart charger did not prevent battery from over heating.
I have used this battery for only about 6 or 7 charge cycles. I noticed it starting to puff a little the last time I went to charge it up. It charged fine and seemed to hold its charge while I used it. After it died I went to charge it about a week later and it will not take a charge and does not work anymore. Maybe it's something I did wrong. I understand how to care for batteries and know batteries do not last forever. But I have only had this battery for a couple months of rather infrequent use since it's for a aeg that does not see to much use.
OJBOOST 27 NY
Pros:
Size- it's small and fits in most of my AEG's
Good rate off fire.
1200mah
Cons:
Did not last long
Started to puff - May have caught fire if it took a charge again
My tenergy lipo's have all lasted way longer
I feel kind of ripped off with this battery
|
will it fit | 0 answers 1 asked |
|
Will this fit
Will this battery fit in my H&K G36C?
3306 days ago Zack L
0
0
(I have this same question)
Staff Answer:
A butterfly will likely work better 3304 days ago 1
0
|
1 answers 1 asked |
|
Fitment
Will this fit into my Lancer Tactical Ak-74u under the dust cover, where the stock battery goes?
3309 days ago Robert S
0
0
(I have this same question)
Staff Answer:
Most likely not, as there is likely not sufficient space. However, a 7.4V LiPo may be able to fit: <BR><BR> <a href="http://www.airsoftgi.com/product_info.php?products_id=11913">Tennergy 7.4V 1000mAh Stick Type LiPo Battery [Link]</a> 3307 days ago 0
0
|
1 answers 1 asked |
|
Fit
Will this battery fit in a standard g&g buffer tube so that I can use a magpul moe stock
3319 days ago matt s
1
0
(I have this same question)
Staff Answer:
As long as no MOSFET nor fuse housing creates an issue as far as space goes, the G&G buffer tube should be able to house this battery. 3319 days ago 0
0
|
1 answers 1 asked |
|
will this fit my kwa sr10?
kwa sr10 crane stock
3329 days ago Teresa L
0
0
(I have this same question)
Staff Answer:
It should 3328 days ago 0
0
|
1 answers 1 asked |
|
Shot count
Roughly, how many shot could i fire out of my AEG with this battery without completely draining it?
3490 days ago Lukas B
0
0
(I have this same question)
Staff Answer:
Ideally, 1 mAh= 1 BB shot in most cases. 3489 days ago 0
0
|
1 answers 1 asked |
|
Will this fit into a buffer tube along with a burst wizard mosfet?
?
3645 days ago Douglas B
0
0
(I have this same question)
Staff Answer:
Most likely, it will <b>not</b> fit. 3643 days ago 0
0
|
1 answers 1 asked |
|
Will this fit in a buffer tube
Looking for loop that fits in magpul stock
3666 days ago Hunter D
0
0
(I have this same question)
Staff Answer:
Yes this will fit in a buffer tube. 3664 days ago 0
0
|
1 answers 1 asked |
|
Will this fit in a standard crane stock
will this fit in an average standard crane stock that comes with most aeg's
3708 days ago Mark B
1
0
(I have this same question)
Staff Answer:
This should fit. 3706 days ago 0
0
|
1 answers 1 asked |
|
do you need a lipo charge for this battery or you can use a regular smart charger
3735 days ago alex m
0
0
(I have this same question)
I would also recommend a LiPo Sack for the battery
3694 days ago
Aron J
0
0
3735 days ago alex m
0
0
(I have this same question)
Staff Answer:
You will need a Li-Po Balance charger for any Li-Po battery. 3734 days ago 0
0
|
2 answers 1 asked |
Other Great Deals and Accessories:
Select the item from the Drop Down Menu and click add.